pQE-TriSystem Vector

No, the pQE-TriSystem vectors contain a T5 Promoter. The expression plasmid used with the EasyXpress Protein Synthesis Insect Kit must contain a T7 Promoter.

Low-level expression can occur because the protein is toxic or unstable, or because the expression construct is not maintained in the cells during growth. In some cases, the 5' end of the inserted DNA sequence may encode elements that interfere with transcription or translation (e.g., masking of the Shine-Dalgarno sequence by stem-loop structures resulting from inverted repeats). In these instances, the sequence being expressed should be checked and modified if necessary. Modifications of growth media and different host strains may also have an effect on expression.

Please review the section "Specific considerations" in the Chapter 'Expression in E. coli' of the QIAexpressionist Handbook and refer to standard literature in protein science (e.g., Current Protocols in Protein Science, eds. John Wiley and Sons, New York) for additional information.

The QIAexpress Protein Purification System allows easy solubilization of 6xHis-tagged proteins sequestered into insoluble inclusion bodies by using denaturants such as 6 M Guanidine-HCl or 8 M Urea, or a variety of detergents. Proteins purified under denaturing conditions can then be refolded if necessary before use (please see: Wingfield, P. T., Palmer, I., and Liang, S.-M. (1995). Folding and purification of insoluble (inclusion-body) proteins from Escherichia coli. In: Current Protocols in Protein Science, vol. 1, Coligan, J. E., Dunn, B. M., Ploegh, H. L., Speicher, D. W., and Wingfield, P.T. eds. Wiley and Sons, Inc. New York, pp. 6.5.1–6.5.27.). The QIAexpressionist also contains recommendations for refolding proteins prior to the Appendix section of the handbook.

To increase levels of soluble protein, here are a few recommendations:

• a reduction in growth temperature following induction may be helpful. Growth temperature often directly affects both expression levels and protein solubility, and lower temperatures will reduce expression levels leading to a higher amount of soluble protein.
• the culture can be grown to a higher cell density before induction and the expression period can be kept to a minimum.
• The IPTG concentration can be reduced from 1 mM to 0.005 mM, which would reduce the expression level by 90–95%.
• it may be sufficient to change the host strain used, since certain strains tolerate some proteins better than others and allow higher levels of expression before forming inclusion bodies.
• many proteins require metal cofactors in order to remain soluble, and the addition of metal salts to the culture media may be helpful. If the metal requirements of the protein are not known, a number of different supplements should be tested. Note that some divalent cations may interfere with protein binding to Ni-NTA.

QIAexpress pQE vectors and constructs can be maintained in any E. coli strain that is ampicillin-sensitive and carries the pREP4 repressor plasmid, or harbors the lacI^q gene on the F-factor episome.

M15 and SG13009 E. coli host strains carry lacI on the plasmid pREP4, while XL1-Blue or the JM series contain an episomal copy of lacI^q.

LacI^q is a mutation of lacI that produces very high levels of the lac repressor. Initial cloning and propagation using XL1-Blue is recommended because plasmid preparations derived from QIAexpress host strains will also contain pREP4 DNA, which could make clone analysis more difficult.

Alternatively, the pQE-80L series of expression vectors which encodes a lacI^q repression module, allows use of any E. coli host strain.