C-Terminus pQE Vector Set

The QIAexpress Protein Purification System allows easy solubilization of 6xHis-tagged proteins sequestered into insoluble inclusion bodies by using denaturants such as 6 M Guanidine-HCl or 8 M Urea, or a variety of detergents. Proteins purified under denaturing conditions can then be refolded if necessary before use (please see: Wingfield, P. T., Palmer, I., and Liang, S.-M. (1995). Folding and purification of insoluble (inclusion-body) proteins from Escherichia coli. In: Current Protocols in Protein Science, vol. 1, Coligan, J. E., Dunn, B. M., Ploegh, H. L., Speicher, D. W., and Wingfield, P.T. eds. Wiley and Sons, Inc. New York, pp. 6.5.1–6.5.27.). The QIAexpressionist also contains recommendations for refolding proteins prior to the Appendix section of the handbook.

To increase levels of soluble protein, here are a few recommendations:

• a reduction in growth temperature following induction may be helpful. Growth temperature often directly affects both expression levels and protein solubility, and lower temperatures will reduce expression levels leading to a higher amount of soluble protein.
• the culture can be grown to a higher cell density before induction and the expression period can be kept to a minimum.
• The IPTG concentration can be reduced from 1 mM to 0.005 mM, which would reduce the expression level by 90–95%.
• it may be sufficient to change the host strain used, since certain strains tolerate some proteins better than others and allow higher levels of expression before forming inclusion bodies.
• many proteins require metal cofactors in order to remain soluble, and the addition of metal salts to the culture media may be helpful. If the metal requirements of the protein are not known, a number of different supplements should be tested. Note that some divalent cations may interfere with protein binding to Ni-NTA.

 

 

The QIAexpress pQE vectors contain a pBR322 derived ColE1 origin of replication and are classified as low-copy plasmids (by our estimate, approximately 20-30 copies per cell; exact numbers have not been determined). The pQE-TriSystem Vector has a pUC origin of replication and is classified as a high-copy vector. Please see also FAQ 350 for general information on replication origins and copy numbers of various commonly used plasmids.

QIAexpress pQE vectors and constructs can be maintained in any E. coli strain that is ampicillin-sensitive and carries the pREP4 repressor plasmid, or harbors the lacI^q gene on the F-factor episome.

M15 and SG13009 E. coli host strains carry lacI on the plasmid pREP4, while XL1-Blue or the JM series contain an episomal copy of lacI^q.

LacI^q is a mutation of lacI that produces very high levels of the lac repressor. Initial cloning and propagation using XL1-Blue is recommended because plasmid preparations derived from QIAexpress host strains will also contain pREP4 DNA, which could make clone analysis more difficult.

Alternatively, the pQE-80L series of expression vectors which encodes a lacI^q repression module, allows use of any E. coli host strain.

The chloramphenicol acetyl transferase gene (CAT) present between t0 and T1 has no promoter and is not normally expressed. Depending on the bacterial strain and insert,low CAT activities may be detectable

To optimize the expression of a given recombinant protein, a time-course analysis of the level of protein expression in the induced culture is recommended. Intracellular protein content is often a balance between the amount of soluble protein in the cells, the formation of inclusion bodies, and protein degradation. By checking the 6xHis-tagged protein present at various times after induction in the soluble and insoluble fractions, the optimal induction period can be established, and the bacterial culture can be harvested at this time. It may be useful to perform plasmid Mini preparations on culture samples during the time-course to enable monitoring of plasmid (expression construct) maintenance.

Below, you can see an example of a time course of recombinant protein expression using the QIAexpress System. You can find this information also in the Section 'Expression in E. coli' in the QIAexpressionist Handbook. The handbook is an important resource for useful background information and protocols. For instructions on how to isolate protein from the soluble and insoluble fractions of induced cultures please see Protocol 14. "Protein minipreps of 6x His-tagged proteins from E. coli under native conditions" and Protocol 19. "6xHis-tagged protein minipreps under denaturing conditions."

 

 

 

Time course of expression using the QIAexpress System. Expression of 6xHis-tagged DHFR was induced with 1 mM IPTG. Aliquots were removed at the times indicated and purified on Ni-NTA Agarose under denaturing conditions. Proteins were visualized by Coomassie staining. Yields per liter culture were 2.8, 5.5,12.3, 33.8, and 53.9 mg, respectively. ■A Crude cell lysate; ■B purification with Ni-NTA. 1: flow-through, 2 & 3: first and second eluates; M: markers; C: noninduced control.