Exonuclease I

For removal of single-stranded primers in PCR reactions

S_1318_9_LS_OEM_Exonuclease_I_30000_U
Need bulk, customized or optimized products for commercial purposes? We also offer support with logistics, compliance and more. Reach out to cooperate with QIAGEN Strategic Partnerships & OEM

Exonuclease I (30,000 U)

Cat. No. / ID:   X8010L

Exonuclease I (20,000 U/mL)
The Exonuclease I is intended for molecular biology applications. This product is neither intended for the diagnosis, prevention or treatment of a disease, nor has it been validated for such use either alone or in combination with other products.
Need bulk, customized or optimized products for commercial purposes? We also offer support with logistics, compliance and more. Reach out to cooperate with QIAGEN Strategic Partnerships & OEM

Features

  • Excises bases on single-stranded DNA in 3ʹ→ 5ʹ direction
  • Removes linear single-stranded DNA, leaving behind double-stranded DNA in the sample

Product Details

Exonuclease I cleaves single-stranded DNA in the 3ʹ→5ʹ direction, releasing 5ʹ mono/di-nucleotides and leaving double-stranded DNA molecules and the 5ʹ terminus intact. The enzyme is processive though digestion is inhibited by a 3ʹ terminal phosphate. Exonuclease I is tolerant of a wide range of buffer conditions and can typically be added to reactions containing magnesium (1–3).

This enzyme is supplied in 10 mM Tris-HCl, 100 mM NaCl, 1 mM DTT, 0.5 mM EDTA and 50% glycerol: pH 7.5 at 25°C.

 

Performance

  • Storage temperature: –25°C to –15°C
  • Molecular weight: 54,500 Daltons
Test Units tested Specification
Purity n/a >99%
Specific activity n/a 185,000 U/mg
Double-stranded endonuclease 200 U No conversion
E. coli DNA contamination 200 U <10 copies

 

Principle

The protein is produced by a strain of E. coli that expresses the recombinant Exonuclease I gene.

One unit is defined as the amount of enzyme required to produce 10 nmol of acid-soluble total nucleotide in 30 minutes at 37°C.

Procedure

Usage Instructions 

Removal of single-stranded DNA from PCR products 

  1. Set up the following reaction mixture in a total volume of 20 µL:
    • 5 µL of PCR product 
    • 10 units of Exonuclease I (X8010L)
  2. Incubate the reaction mixture at 37°C for 15 minutes. 
  3. Heat inactivate enzyme at 80°C for 15 minutes.

Notes: 

  1. Exonuclease I will preferentially degrade single-stranded oligonucleotide primers in a reaction containing amplification products or other sources of double-stranded DNA, leaving double-stranded molecules intact.
  2. Exonuclease I, combined with Lambda Exonuclease (X8030L), effectively removes linear DNA species from plasmid preparations. 
  3. Exonuclease I works well in most molecular biology buffers that contain magnesium over 1.5 mM. 

References: 


1. Lehman, I.R. and Nussbaum, A.L. (1964) J. Biol. Chem., 239, 2628. 
2. Kushner, S.R. et al. (1971) Proc. Natl. Acad. Sci. USA, 68, 824. 
3. Kushner, S.R. et al. (1972) Proc. Natl. Acad. Sci. USA, 69, 1366. 

Quality Control 

Unit activity was measured using a twofold serial dilution method. 

Dilutions of the enzyme were made in an Exonuclease I storage solution containing glycerol (50%) and added to 50 µL reactions containing a single-stranded tritiated DNA fragment and 67 mM glycine-KOH (pH 9.5), 10mM DTT, 6.7 mM MgCl2. Reactions were incubated for 10 minutes at 37°C, placed on ice, and analyzed using a TCA-precipitation method.

Protein concentration is determined by OD280 absorbance.

Physical purity is evaluated by SDS-PAGE of concentrated and diluted enzyme solutions followed by silver-stain detection. Purity is assessed by comparing the aggregate mass of contaminant bands in the concentrated sample to the band's mass corresponding to the protein of interest in the diluted sample.

Double-stranded endonuclease activity is determined in a 50 µL reaction containing 0.5 µg of plasmid DNA and 10 µL of enzyme solution incubated for 4 hours at 37°C.

E. coli contamination is evaluated using 5 µL replicate samples of enzyme solution that are denatured and screened in a TaqMan qPCR assay for the presence of contaminating E. coli genomic DNA using oligonucleotide primers corresponding to the 16S rRNA locus.

 

Applications

This product is available for molecular biology applications such as:

  • Plasmid prep cleanup
  • Removes ssDNA from a mixture of linear ssDNA and dsDNA
  • Removes oligonucleotide primers after PCR

Resources

Protocol Files (1)
Safety Data Sheets (1)
Certificates of Analysis (1)